Read Sharp MX-FNX5 (serv.man2) Service Manual online
MX-M1100 MX-PNX3A / B / C / D 12 – 1
MX-M1100
Service Manual
[12] MX-PNX3A / B / C / D
* This punch unit is for MX-FNX5.
Separate the finisher from the copier when installing the punch
unit.
unit.
1. Unpacking
1)
Remove the protector plate with a red tag.
2. Installation
A. Installation of punch module
1)
Remove the Inner cover.
2)
Cut out the inner cover using a cutter and so on.
3)
Remove the rear cover.
4)
Remove the paper guide. (2 screws front and 2 screws rear)
5)
Attach the sensor arm. (1 screw) (A stepped screw)
* Please make sure that the sensor arm moves smoothly.
* Please make sure that the sensor arm moves smoothly.
6)
Attach a spring.
Protector plate
(not required)
(not required)
CAUTION
Switch the machine off and unplug the machine before starting the
following procedure.
following procedure.
Cut out with a cutter etc.
Inner cover
Rear cover
Paper guide
Sensor arm
Spring
Sensor arm
Install stepped screw.
Spring
MX-M1100 MX-PNX3A / B / C / D 12 – 2
7)
Insert the punch unit and fix it with 2 screws.
8)
Attach the spacer.
9)
Attach the Punch unit knob. (1 screw)
10) The cover removed in step 1 can be installed now.
11) Connect the 3 connector as shown in the illustration.
11) Connect the 3 connector as shown in the illustration.
12) Install the punch waste collection container.
13) Attach the rear cover.
Punch unit
Spacer
Punch unit knob
3
2
1
Punch waste collection
Display