Read Sharp MX-FN30 / MX-FN31 (serv.man6) Technical Bulletin online
2. The modification has been made on the following parts for productivity improvement:
(9) Change of the plate thickness of Stapler pulley As (PLATE, STAPLER, PULLEY, ASSEMBLY)
(10) Change of the plate thickness of Staple drive caulking As (CAULKING, STP), addition of TP
screws, and disuse of E-ring
* As the result of this change, this parts can no longer be installed in the field. For this reason,
this parts will not be supplied as the service parts.
* When replacing the parts above, please use STAPLE MOUNT ASS’Y (0CW4M511710//).
(11) Change of the plate thickness of NS staple upper plate As
(BRACKET, STP, NS, UP)
(12) Along with the change of (11), the design of Guide has been changed.
*This parts needs to be replaced together with (11).
Locations of (1) Processing front frame (FRAM, OPE, TRAY, FRONT) and (2) Processing rear frame
(FRAM, OPE, TRAY, REAR)
(Part Guide 3 INTERNAL COMPONENTS 1)
(Part Guide 4 INTERNAL COMPONENTS 1)
Plate thickness of
Processing rear frame
(FRAM, OPE, TRAY, REAR)
Before change: 0.6mm
After change: 1.0mm
Processing rear frame
(FRAM, OPE, TRAY, REAR)
Before change: 0.6mm
After change: 1.0mm
Plate thickness of
Processing front frame
(FRAM, OPE, TRAY, FRONT)
Before change: 0.6mm
After change: 1.0mm
Processing front frame
(FRAM, OPE, TRAY, FRONT)
Before change: 0.6mm
After change: 1.0mm
Click on the first or last page to see other MX-FN30 / MX-FN31 (serv.man6) service manuals if exist.