Read Sharp MX-FN21 / MX-FN22 / MX-PN13 (serv.man5) Service Manual online
MX-7040N MX-PN13A/B/C/D (PUNCH MODULE) 21 – 3
2) Pull out the saddle unit until it stops. (MX-FN22 only)
C. Punch open support plate installation
(MX-FN21 only)
1) Remove the magnet plate.
2) Purchase assembling
Attach the punch handle ( Packed items No.13) and spring
hook plate (Packed items No.12) to the punch open support
plate (Packed items No.1) with the screw ( Packed items
No.10) and the step screw (Packed items No.11).
3) Purchase installation
Install the purchase to the finisher with screw (Packed items
No.10).
D. Punch dust full sensor installation
1) Attach the punch dust full sensor unit (Packed items No.6) with
the screw (Packed items No.15).
E. Punch unit installation
NOTE:
Hold the punch unit as shown in the figure below.
NOTE:
Do not hold the motor gear.
1) In the front side of the punch unit, fit the hole in the punch unit
with the pin in the finisher side then push down the entire unit.
Step screw
Click on the first or last page to see other MX-FN21 / MX-FN22 / MX-PN13 (serv.man5) service manuals if exist.