Read Sharp MX-FN18 Service Manual online
MX-FN18 ADJUSTMENTS AND SETTINGS 3 – 3
D. Stitch position (Center stapling adjustment)
Use the user mode of the host machine for this adjustment.
E. Adjustment of stitcher unit
1)
Open the front cover.
2)
Pull out the stitcher base unit to the front, and pull the stitcher
handle [1] once and raise the stitcher.
handle [1] once and raise the stitcher.
3)
Remove the three screws [2], and remove the stitcher cover
[3].
[3].
4)
Remove the positioning tool [4] attached to the back of the
cover.
cover.
5)
For adjustment of the stitcher in the front side, remove the front
guide plate [5] and the center guide plate [6]. For adjustment of
the stitch in the rear side, remove the center guide plate [6]
and the rear guide plate [7]. (one screw, each)
guide plate [5] and the center guide plate [6]. For adjustment of
the stitch in the rear side, remove the center guide plate [6]
and the rear guide plate [7]. (one screw, each)
6)
For adjustment of the stitcher in the front side, loosen the two
screws [9] of the stitcher base [8]. For adjusting of the stitcher
in the rear side, loosen the two screws [10] of the stitcher base
[8].
screws [9] of the stitcher base [8]. For adjusting of the stitcher
in the rear side, loosen the two screws [10] of the stitcher base
[8].
7)
Insert the tool [12] into the staple slot of the stitcher [11].
8)
Tilt the stitcher. Then, rotate the stitch gear [13], fit the tool [14]
and the concave section of the base [15], and tighten the
screw of the base [15] to fix.
and the concave section of the base [15], and tighten the
screw of the base [15] to fix.
[2]
[3]
[1]
[4]
[7]
[6]
[5]
[10]
[9]
[8]
[11]
[12]
[15]
[14]
[13]
Click on the first or last page to see other MX-FN18 service manuals if exist.