Read Sharp MX-EB13 (serv.man2) User Guide / Operation Manual online
Wireless LAN Operational Procedure (for Overseas)
10
June 29. 2012
desired client device and then
click the [Release] key.
click the [Release] key.
3.2.2.
Initializing Wireless Settings
When the [Initialize] key in the bottom of the Wireless Settings screen is clicked, a message appears asking
whether initialization of the Wireless Settings is desired. When the [OK] key in the message is clicked, the
Wireless Settings return to factory defaults.
3.2.3.
whether initialization of the Wireless Settings is desired. When the [OK] key in the message is clicked, the
Wireless Settings return to factory defaults.
3.2.3.
Changing Wireless Settings
When the [Settings] key in the bottom of the Wireless Settings screen is clicked, a screen for changing the
Wireless Settings appears.
Name
Wireless Settings appears.
Name
Setting in Infrastructure Mode
Setting in Ad-hoc Mode
SSID
Enter the SSID of the access point of the
MFP.
Enter the SSID for client devices to connect
to in Ad-hoc Mode.
Security type
Select from the following types the
security type that is set for the access
point:
1. None (Default)
2. WEP
3. WPA-Personal
4. WPA-Enterprise
5. WPA2-Personal
6. WPA2-Enterprise
Select a security type to use between mobile
devices and the MFP.
In Ad-hoc Mode, only [WEP] or [None] can be
selected.
Encryption
Select an encryption type.
When the security type is set to [WEP], this setting is grayed out.
When the security type is set to [None], either [WEP] or [None] can be selected for
encryption.
When the security type is set to either [WPA-Personal], [WPA-Enterprise],
[WPA2-Personal] or [WPA2-Enterprise], either [TKIP] or [AES] can be selected for
encryption.
Security key
Enter the security key.
WEP 64 bit: 5 characters or a 10-digit hex
number.
WEP 128 bit: 13 characters or a 26-digit
hex number.
WPA/WPA2: 8-63 characters or a 64-digit
hex number.
Enter the security key.
In Ad-hoc Mode, only WEP 64 bit is available.
Showing security
key
Change this setting to [ON] show the security key. The factory default is [OFF].
Device IP
Address (Ad-hoc
Mode)
(Not shown)
Set an IP address of the MFP for Ad-hoc
Mode. (Set a different segment from the IP
address for a wired LAN when such is also
used.)
Channel to be
used
(Not shown)
Note: In Infrastructure Mode, the channel
used by the access point is automatically
selected.
Select a channel from the range of 1 to 14 for
Ad-hoc Mode.
The factory default is [6].
Transmission
level
(Not shown)
Select an electric wave transmission level for
Ad-hoc Mode from the three options: 1
(Low), 2 and 3 (High).
The factory default is [3 (High)].
Click on the first or last page to see other MX-EB13 (serv.man2) service manuals if exist.