MX-CS12N, MX-CS13N. Service Manual. - Sharp Copying Equipment Service Manual (repair manual). Page 6

MX-CS12 N/CS13 N AR-DS19/DS20  ADJUSTMENT  4 - 1

Set a document on the document glass and make a copy.

*

If the image center is shifted, perform the following procedure.

1) Execute SIM 50-10 with the key operations on the copier.

2) Turn  on  the  Auto  indicator  and  the  indicator  of  a  corresponding

paper tray by Light and Dark key, Enter the set value with the keys
on the operation panel to perform the center shift adjustment, make
a copy again, and check that the center is not shifted.

-  When the set value is increased, the image is shifted to the rear

side.

- When the set value is decreased, the image is shifted to the front

side.

After  completion  of  the  adjustment,  press  the 

  key  to  cancel  the

mode.

Note: To  make  the  paper  center  shift  adjustment  and  the  lead  edge

adjustment,  insert  the  power  plug  of  the  copier  into  the  power
outlet, turn on the power switch, and perform the following proce-
dure.

Set a document on the document glass, and make a copy.

1) Execute SIM 50-1 with the key operations on the copier.

2) Turn  on  the  Auto  indicator  and  the  indicator  of  a  corresponding

paper tray by Light and Dark key, Enter the set value with the keys
on the operation panel and make a copy to check that the lead edge
is within the specified range.

- When the set value is increased, the copy image moves forward.

- When the set value is decreased, the copy image moves back-

ward.

After  completion  of  the  adjustment,  press  the 

  key  to  cancel  the

mode.

Follow these steps to change a tray’s paper size setting.

Note:

- The paper size setting cannot be changed when the machine has

stopped  temporarily  due  to  running  out  of  paper  or  a  misfeed,  or
during interrupt copying.

- During printing (even in copy mode), the paper size setting cannot

be changed.

- Do not load paper that is a different size than the paper size set-

ting. Copying will not be possible.

1) Hold  down  the  [PAPER]  key  for  more  than  5  seconds  to  set  the

selected paper size.

The  currently  selected  paper  feed  location  indicator  will  blink  and
the corresponding paper  size  (which is currently  set) indicator will
display.

2) If the machine has two or more paper trays, use the [TRAY] key to

select the paper tray for which you wish to change the paper size
setting. Each time the [TRAY] key is pressed, a paper tray will be
indicated with a blinking paper feed location indicator. 

C

5

0

1

0

[READ-END] key #

Paper output direction

Front side

Printing side

Rear side

Center line of image

Center line 
of paper

Output direction

1

Leading edge

Printing side

Printing side

Output direction

Center line 
of paper

Leading edge

Center line of image

1

CA

C

5

0

0

#

1

[READ-END] key

CA