MX-CF10. Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 8

MX-CF10  OPERATIONAL DESCRIPTION  4 - 4

Step 17: When the inserter reverse motor has completely stopped, the

inserter reverse motor starts to reverse, and the transport
motor starts.

Step 18: The inserter reverse sensor is turned ON, and detects the

leading edge of the sheet.

Step 19: The inserter paper exit sensor is turned ON, and detects the

leading edge of the sheet.

Step 20: The inserter reverse sensor is turned OFF.  When the sheet

travels a predetermined distance after its trailing edge is
detected, the inserter reverse motor stops.
(If the next sheet waits at the leading-edge registration posi-
tion, the flapper solenoid in the reverse section is turned ON,
the inserter paper feed motor starts to rotate in the forward
direction, and the inserter reverse motor starts to rotate in the
forward direction.)

Step 21: The inserter paper exit sensor is turned OFF, and the trailing

edge of the sheet is detected.

Step 22: If there are no more sheets to be inserted, the transport

motor stops.

The figure below shows the operator panel.

Setting procedure: 

Step 01: Place a sheet in the tray.

Step 02: Press the PUNCH switch on the operator panel.

Step 03: The PUNCH LED lights up to indicate that setting has been

completed.

Step 04: Press the START switch to start operation.

Canceling procedure:

Step 01: Press the PUNCH switch on the operator panel.

Step 02: The PUNCH LED goes out to indicate that setting has been

canceled.

Note: If you cannot make or cancel setting by following the respective

procedures above, refer to section “5.” shown later. When no
LEDs are lit, check the setting made by the main unit and the
inserter status.

Setting procedure: 

Step 01: Place a sheet in the tray.

Step 02: Press the STAPLE MODE switch on the operator panel.

Step 03: Each time you press the switch, the STAPLE MODE LEDs

light up by turns in the following order: 1 

→ 2 → 3 → 4 → All

LEDs OFF 

→ 1 → ... (When the saddle mode cannot be

used, the order is: 1 

→ 2 → 3 → All LEDs OFF → 1 → ...) 

Step 04: When the desired LED lights up, press the START switch to

start operation.

(Refer to the correspondence between the stapling modes and LEDs
shown later.)

Canceling procedure: 

Step 01: Press the STAPLE MODE switch on the operator panel.

Step 02: All the STAPLE MODE LEDs go out to indicate that setting

has been canceled.

Note 1:

If you cannot make or cancel setting by following the respec-
tive procedures above, refer to section “5.” shown later.
When no LEDs are lit, check the setting made by the main
unit and the inserter status.

Note 2:

The punching mode and saddle mode cannot be used at the
same time.

Punch switch

Punch LED

Start switch

Start LED

Start switch

Staple mode switch

Start switch

Staple mode LED 4

Staple mode LED 3

Staple mode LED 2

Staple mode LED 1