MX-C250, MX-C250E, MX-C250F, MX-C250FE, MX-C250FR, MX-C300F, MX-C300W, MX-C300WE, MX-C300A, MX-C300WR (serv.man61). CCE1287 FUSING RELEASE LEVER NEWLY SET UP AS SERVICE PARTS - Sharp Copying Equipment Technical Bulletin (repair manual). Page 3

Read Sharp MX-C250 / MX-C250E / MX-C250F / MX-C250FE / MX-C250FR / MX-C300F / MX-C300W / MX-C300WE / MX-C300A / MX-C300WR (serv.man61) Technical Bulletin online

4
4.
After inserting the pressure SP into the
hole of fusing frame in the area
indicated with green circle at Step 3,
hook it to the fusing release lever like
the left  picture.
11
11.
* Spring mounting groove is in the area
indicated with blue circle of No.11.
Fit the spring mounted to the rear lower
PG into the groove.
2
2.
Once the pressure roller levers are lifted
up at Step1, hold them lightly by hands
to prevent from opening.
9
9.
Insert the boss of the rear lower PG into
the hole located on F side in the left
picture.
3
3.
Insert the pressure SP into the hole of
the fusing frame in the area indicated
with green circle, and hook it to the
fusing release lever.
After hooking it to the fusing release
lever, hook it to the groove of fusing
frame.
(For both F/R)
10
10.
After inserting the rear lower PG (F
side) into the fusing frame at Step 9,
mount the rear lower PG (R side) like
the pictures of No. 11 and 12.
Fusing release lever -  Replacing Manual (Assembling)
1
1.
After replacing the fusing release lever,
lift up the pressure roller levers at
 both
F/R
 like the left picture.
8
8.
Insert the boss of rear lower PG in the
area indicated with red circle into the
hole of the fusing upper frame in the
direction of arrow.
As for the hole to be inserted, please
see Step 10.
6
6.
Reverse the unit 180-degree from the
state of Step 5.
Lift up the fusing release levers at both
F/R sides in the areas indicated with red
circle and then make the situation under
pressure.
13
13
Mount the screw of F side in the area
indicated with red circle.
7
7.
Hook the support SP to the hole of the
pressure roller lever and the hole of the
fusing frame on the lateral side.
Be sure to mount it for both F/R.
This is the end of
assembling.
5
5.
Check if the pressure SP is correctly
assembled.  (For both F/R)
12
12.
Check that the spring mounted to the
rear lower PG is fit into the fusing frame
and also the boss is fit into the hole.
Page of 3
Display

Download Sharp MX-C250 / MX-C250E / MX-C250F / MX-C250FE / MX-C250FR / MX-C300F / MX-C300W / MX-C300WE / MX-C300A / MX-C300WR (serv.man61) Technical Bulletin