Read Sharp MX-C250 / MX-C250E / MX-C250F / MX-C250FE / MX-C250FR / MX-C300F / MX-C300W / MX-C300WE / MX-C300A / MX-C300WR (serv.man2) Handy Guide online
Initial Setup
TONER INSTALLATION & REPLENISHMENT
Developer setup has been executed during machine production therefore, it
is not necessary to execute Sim25-02 after unpacking the machine.
is not necessary to execute Sim25-02 after unpacking the machine.
Remove Protective Caps from Developer Units (x4).
(Please retain the Caps as they are used for transporting).
(Please retain the Caps as they are used for transporting).
Install CMYK Toner Cartridges.
Caution:
DO NOT open any Exterior Cover, Power OFF/ON or enter Simulation Mode
during Initial Toner Replenishment.
during Initial Toner Replenishment.
PRODUCT ACTIVATION & FIRMWARE UPGRADE
Activation of Optional Product (E-RIC only).
Sim 22-05 Check Firmware version(s):-
Upgrade to latest version
.
INITIAL SETUP
Sim 26-06 Machine Destination.
Sim 26-35 Set Multi Error Counter
Set to 1 (Multi Count).
System Settings: Adjust Date/Time (Inc. Daylight Saving setting).
Set cassette size by adjusting the guides in the cassette.
PRINT IMAGE POSITION & MAGNIFICATION
Manual Adjustment:-
Sim 50-10 BK MAG (inside dimension).
Measure the length of 14 squares around the centre area of
the test print and check whether the length is 140 +/- 0.7mm.
the test print and check whether the length is 140 +/- 0.7mm.
Sim 50-10 Image Off Centre Adjustment.
Sim 50-05 Printer Lead Edge & Void Adjust.
IMAGE SKEW & COLOUR REGISTRATION
Sim 50-22 Colour Registration/Skew & OPC Drum Phase Adjustment
Check/Adjust SKEW (CMY) so value is within the following range:-
SKEW_C : +/-30, SKEW_M : +/-40, SKEW_C : +/-20 (Result=OK).
SKEW_C : +/-30, SKEW_M : +/-40, SKEW_C : +/-20 (Result=OK).
ENGINE HALF TONE COLOUR CALIBRATION
Sim 46-24 Colour Balance Adjustment/Calibration.
6
SHARP
Document Solution Centre
Click on the first or last page to see other MX-C250 / MX-C250E / MX-C250F / MX-C250FE / MX-C250FR / MX-C300F / MX-C300W / MX-C300WE / MX-C300A / MX-C300WR (serv.man2) service manuals if exist.