Read Sharp MX-6500N / MX-7500N (serv.man105) Technical Bulletin online
Sharp Electronics (UK) Ltd., Technical Services Group
CCE-
Open the regulate plate to it’s maximum
If the cut-out of the gear does not match the pawl, unscrew the P-tight M3x8 screws marked
below, and remove the width detection mounting plate
• Regulation plate must be opened to the maximum at both ends
Refit the width detection mounting plate and fasten with P-tight M3x8 screws
Check if the cut-out position of the gear matches the
pawl of the width detection mounting plate
Manual feed detection
pinion gear position
When the regulate plate is open to it’s
maximum width, check if the cut-out
position of the gear lines up with the pawl of
the width detection mounting plate
maximum width, check if the cut-out
position of the gear lines up with the pawl of
the width detection mounting plate
Adjust the cut-out
of the gear to the
direction of the
boss
of the gear to the
direction of the
boss
Click on the first or last page to see other MX-6500N / MX-7500N (serv.man105) service manuals if exist.