MX-6240N, MX-7040N (serv.man16). Installation Manual (Revised May 2017). - Sharp Copying Equipment Service Manual (repair manual). Page 19

MX-7040N  MX-6240N/7040N (MAIN UNIT)  2 – 9

3)

Turn the felt side of the cleaning bar downward and insert it.
Slide it back and forth a few times to clean the LSU dust-proof
glass.

4)

Replace the LSU claning bar to the front cover, and close the
front cover.

1)

Touch the [Paper Tray Settings] key.

2)

Touch the [Paper Tray Settings] key to configure the settings.
These settings specify the paper type, paper size, and func-
tions allowed for each paper tray. When the [Tray Settings] key
is touched, a list appears showing the trays and the current
settings.

3)

Touch the [Change] key in the above screen to change the set-
tings. The following settings can be configured.

1)

Open the tandem paper feed tray.

2)

Push down the paper feed base plate gently, hold the hooks
and remove A4 size regulation plate.

3)

Fit the A4 size regulation plate to A4 size, and attach it.

* Be careful to place and direction that install the sheet.

4)

Close the tandem paper feed tray.

Type

Select the type of paper that is loaded in the tray. 
The paper types that can be selected vary by paper 
tray.

Size

Select the paper size from the list. The paper sizes 
that can be selected vary by tray. The sizes that 
can be selected may also be restricted by the paper 
type selected above. 
If the desired size does not appear in the list, select 
[Custom Size] and directly enter the size (only for 
the bypass tray).

Feeding Approved 
Job

Select the modes that can be used. If there is a 
function that you do not wish to be used with the 
selected tray, disable the function. When the "Type" 
is other than plain paper, recycled paper, colored 
paper, or a user type, [Fax] and [Internet Fax] 
cannot be selected.