Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man69) Service Manual online
MX-7000N PWB SECTION R – 5
2)
Disconnect the connectors (A). Remove the screws (B). Dis-
connect the connector (C), and remove the Mother PWB (D).
connect the connector (C), and remove the Mother PWB (D).
(9) MFP cnt PWB
1)
Remove the right cabinet rear. (Refer to the "[A] EXTERNAL
OUTFIT".)
OUTFIT".)
2)
Remove the screws (A). Raise the finger hooks (B), and pull
out the control box (D) until the position in which the clamp (C)
is seen. Remove the harness (E) from the clamp (C).
out the control box (D) until the position in which the clamp (C)
is seen. Remove the harness (E) from the clamp (C).
3)
Pull out the control box (G) until the position in which the con-
nector (F) is seen. Pull the sheet (H), and remove the connec-
tor (F).
nector (F) is seen. Pull the sheet (H), and remove the connec-
tor (F).
* When installing, check that the harness (I) is put on the
mylar (J).
* Check that the harness is not twisting, hanging down, etc.
4)
Remove the screws (K), and remove the MFP cnt PWB (L).
Parts
i
MFP cnt PWB
D
h
A
B
B
B
B
C
i
A
A
B
D
C
E
F
G
H
J
I
L
i
K
K
K
K
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man69) service manuals if exist.