MX-5500N, MX-6200N, MX-7000N (serv.man37). AR-PF1-Barcode Font kit-Installation Manual - Sharp Copying Equipment Peripheral (repair manual). Page 2

MX-7000N  AR-PF1  11 – 2

3)

Hold the snap band to arrow direction, and remove it, and
remove the I/F cable.

4)

Pull out the control box until the position in which the clamp is
seen. Remove the HDD-IDE cable from the clamp.

5)

Pull out the control box until the position in which the connector
of the HDD-IDE cable is seen. Pull the sheet, and remove the
HDD-IDE cable.

1)

Install the barcode font ROM PWB to the barcode connector.
* Check to confirm that the silver push lever extends out when

the PWB is installed.

* The connector position is indicated by the silk print on the

PWB.

1)

Insert the control box until the connectable position for HDD-
IDE cable, connect the HDD-IDE cable.

2)

Insert the control box until the position that fix the HDD-IDE
cable to the clamp, put the HDD-IDE cable to the sheet (A),
and fix it to the clamp.
* Check that the HDD-IDE cable is not twisting, hanging

down, etc.

BOOT

BARCODE

PCL/BUMON

PS KANJI

PROGRAM2

PROGRAM1

FAX IMG EXT