MX-5500N, MX-6200N, MX-7000N (serv.man26). MX PEX2 INSTALLATION MANUAL - Sharp Copying Equipment Peripheral (repair manual). Page 2

MX-PEX2  Configuration  1 – 1

MX-PEX2

Service Manual

 

1)

Remove the print controller unit.

1)

Check that all the items are included in the package.

The MFP model is detected when the power is turned on for the first time after the shipment from the factory, and the system that matches the
MFP (MX-5500N/6200N/7000N or MX-3500/4500 series) is started.
After the system is started, the initial setup screen is displayed.
After the completion of the setup, the detection of MFP model at the boot-up will not be executed.
It is necessary to return the controller to the default state if you want to re-connect it to another MFP after the setup.
System setting 

→ Printer Setting (administrator area) → Fiery Setting → Run Setup

Password: Fiery.1 (Default) 

→ Factory Default

NOTE: Please make sure to reset to the default state if you connect the controller to another model, because the controller starts

NOTE: MX-PEX1 was shipped after setting the basic setting (the information of MFP) by default, but MX-PEX2 is shipped in the fac-

MX-3500/4500 series

YES

YES

MX-5500N/6200N/7000N

NO

YES

1

I/F unit

1

2

Step screw

2

3

LAN cable (cross cable)

1

4

AC power cable

1

5

Caution label

1

6

CD-ROM

7

7

Quick guide

1

8

Release notes

1

9

KODAK chart

1

1

4

2

3

6

7

8

5

9