Read Sharp MX-4100N / MX-4101N / MX-5000N / MX-5001N (serv.man16) Service Manual online
MX-4101N MAINTENANCE 8 – 20
10) Remove the screws, and remove the primary transfer belt
drive gear.
Maintenance: Replace at every 300K.
Maintenance: Replace at every 300K.
11) Remove the parts.
12) Remove the screws, and remove the paper guide.
13) Fold the transfer frame and lift the rear side and put the trans-
fer unit straight. Remove the intermediate transfer belt.
Maintenance: Replace at every 300K.
Maintenance: Replace at every 300K.
[Installing method]
Make the intermediate transfer belt into triangle. Attach the
intermediate transfer belt to the transfer frame.
Make the intermediate transfer belt into triangle. Attach the
intermediate transfer belt to the transfer frame.
NOTE: When installing, be careful not to bring the intermediate
transfer belt into contact with the transfer unit frame and
the gears. Use care not to touch the intermediate transfer
belt surface with bare hand.
When installing, put the unit so that the lot number speci-
fied on the back surface of the bead is on the front side.
the gears. Use care not to touch the intermediate transfer
belt surface with bare hand.
When installing, put the unit so that the lot number speci-
fied on the back surface of the bead is on the front side.
14) Clean the primary transfer belt drive roller.
Maintenance: Clean at every 300K.
15) Clean the belt CL brush.
Maintenance: Clean at every 300K.
Click on the first or last page to see other MX-4100N / MX-4101N / MX-5000N / MX-5001N (serv.man16) service manuals if exist.