Read Sharp MX-4100N / MX-4101N / MX-5000N / MX-5001N (serv.man131) Technical Bulletin online
〔16〕 MX-FR11/FR11U
1. Unpacking
A. Check the packed items
1) Check that all the items are included in the package
1
2
3
4
5
6
No.
Packed part names
Quantity
1
MFP_PRG1 ROM
1
2
MFP_PRG2 ROM
1
3
Operation manual
1
4
Caution sheet (MX-FR11only)
1
5
USB memory
1
6
Certificate label
(MX-FR11only)
1
2. Installation
<Note before installation>
* To enable the data security function, the product key
* To enable the data security function, the product key
must be acquired (For the method of acquiring the
product key, contact the dealer.)
product key, contact the dealer.)
* Before installing the data security kit, be sure to
perform backup of data stored in the memory
(including HDD) of the main unit. When the data
security kit is installed, all the job data stored in the
memory (including HDD) of the main unit will be lost.
(including HDD) of the main unit. When the data
security kit is installed, all the job data stored in the
memory (including HDD) of the main unit will be lost.
* If the LINE indicator or the DATA indicator for the
printer and image transmission on the operation panel
is lit or blinking, data that has not been processed
remains in the memory of the main unit (including
HDD). Output or transmit all the data to clear the data
remaining in the main unit and then start installation.
(Check to insure that neither the LINE indicator nor the
DATA indicator on the operation panel does light up or
blink.)
is lit or blinking, data that has not been processed
remains in the memory of the main unit (including
HDD). Output or transmit all the data to clear the data
remaining in the main unit and then start installation.
(Check to insure that neither the LINE indicator nor the
DATA indicator on the operation panel does light up or
blink.)
A. Turn off the power switch of the main unit.
1) Turn the power switch located on the operation
panel to the
“OFF” position.
2) After checking that the operation panel has gone
out, open the front cabinet and turn the main power
switch to the
switch to the
“OFF” position.
3) Remove the power plug of the main unit from the
outlet.
B. Pull out the control PWB.
・ If cables are connected to the control PWB unit,
remove all cables.
1) Push the location indicator in the illustration to
unlock, and remove the ozone filter cover from the
right rear cabinet.
right rear cabinet.
2) Remove the screw from the right rear cabinet.
3) Remove the right rear cabinet.
4) Remove the two screws from the control PWB unit.
3) Remove the right rear cabinet.
4) Remove the two screws from the control PWB unit.
・If the fax box unit is installed, carry out steps 5),6)
and 7) additionally.
and 7) additionally.
5) Pull out the control PWB unit and remove the snap
band.
6) Remove the interface cable from the frame.
7) Remove the connector.
8) Pull out and remove the control PWB unit.
7) Remove the connector.
8) Pull out and remove the control PWB unit.
1/4
Common Criteria
Validated
MFP Data Security Kit
Validated
MFP Data Security Kit
Click on the first or last page to see other MX-4100N / MX-4101N / MX-5000N / MX-5001N (serv.man131) service manuals if exist.