Read Sharp MX-3500N / MX-3501N / MX-4500N / MX-4501N (serv.man11) Service Manual online
MX3500N MX-LCX1 4 – 7
b. Auxiliary guide size switch
* Since the auxiliary guide setting is not required, fix the auxiliary
* Since the auxiliary guide setting is not required, fix the auxiliary
guide to either of A4 or LT. (To prevent against missing of the
part)
part)
c. Rear edge shaft switch
1)
1)
Remove the rear edge shift fixing screw (blue screw) which is
fixing the shaft to the right side inside the tray, and remove the
rear edge shaft.
fixing the shaft to the right side inside the tray, and remove the
rear edge shaft.
2)
Insert the removed rear edge shaft into the mounting hole in
the paper feed desk as shown in the figure below. Fix the
upper section with the fixing screw (blue screw) which was
removed previously.
the paper feed desk as shown in the figure below. Fix the
upper section with the fixing screw (blue screw) which was
removed previously.
NOTE:
When the rear edge shaft is switched to B5, check to confirm
that the side plates F/R are already set to B5. If the side plates
F/R are not set to B5, the rear edge shaft cannot be switched
to B5.
When the rear edge shaft is switched to B5, check to confirm
that the side plates F/R are already set to B5. If the side plates
F/R are not set to B5, the rear edge shaft cannot be switched
to B5.
3)
Slightly push the tray, restore the stopper to the original posi-
tion, and fix the fixing screw.
tion, and fix the fixing screw.
At that time, check to insure that the stopper pawl is engaged
with the stopper reception of the large capacity tray unit.
with the stopper reception of the large capacity tray unit.
4)
Slowly insert the tray to the original position.
F. Turn on the power of the main unit
1)
Connect the earth cord, and insert the power plug of the main
unit into the power outlet.
unit into the power outlet.
F side
R side
Click on the first or last page to see other MX-3500N / MX-3501N / MX-4500N / MX-4501N (serv.man11) service manuals if exist.