Read Sharp MX-2630 (serv.man6) Handy Guide online
SHARP
PCU PWB REPLACEMENT PROCEDURE
MX-2630N Handy Guide NOV’17
Sharp Office Solutions Group
Page 65
/75
In order to reset the temperature control for the non-contact thermistor, please replace the PCU PWB using the
following procedure:-
following procedure:-
1. Power off the MFP and remove the rear cover.
2. Unplug the PCU connectors and FFC, and
remove the PCU PWB fixing plate unit.
3. Replace the PCU PWB - ensure to transfer the
original EEPROM & Flash ROM onto the
replacement PCU PWB.
replacement PCU PWB.
4. Attach the connectors and insert the FFC with
CAUTION
:-
INSERT FFC *1
INSERT FFC *2
5. Remove the Fuser Unit.
6. Close all the exterior doors and Power ON the
MFP (with the Fuser Unit removed).
7. Wait 10 seconds - “Check Fusing Unit” should
be displayed and then Power OFF the MFP.
8. Install the Fuser Unit and Power ON the MFP.
9. Check/Verify the MFP Operation following PCU
PWB replacement.
10. Power OFF the MFP and refit the rear cover.
Click on the first or last page to see other MX-2630 (serv.man6) service manuals if exist.