Read Sharp MX-2614N / MX-3114N (serv.man132) Technical Bulletin online
Procedure to add Gum damper and Poly slider to the section of DV drive 58T (Black)
Work Procedure:
1. Remove the main drive UN.
2. Remove the E Ring
3. Remove the gear (Black) and the parallel pin. (Be careful not to lose the parallel pin.)
4. Insert the parts in the order of Poly slider, gum damper, and gear (Black).
1. Remove the main drive UN.
2. Remove the E Ring
3. Remove the gear (Black) and the parallel pin. (Be careful not to lose the parallel pin.)
4. Insert the parts in the order of Poly slider, gum damper, and gear (Black).
5/6
4. Insert the parts in the order of Poly slider, gum damper, and gear (Black).
5. Insert the parallel pin, and then insert the gear (Black) adjusting to the parallel pin.
6. Install E Ring.
5. Insert the parallel pin, and then insert the gear (Black) adjusting to the parallel pin.
6. Install E Ring.
E Ring
E Ring
Parallel pin
Gum damper
Poly slider
Gear 58T
Pawl of E-Ring must be set to
th
th
f th
h ft
the grooves of the shaft.
Do not set to the flat area.
Do not set to the flat area.
5/6
5/6
Click on the first or last page to see other MX-2614N / MX-3114N (serv.man132) service manuals if exist.