Read Sharp AR-RP3 Service Manual online
7. Attach the RSPF.
Insert the hinge portion of the RSPF to the mounting portion of the
copier by holding the RSPF at an angle toward the rear side.
copier by holding the RSPF at an angle toward the rear side.
8. Connect the relay connector.
Connect the Centronics connector of the RSPF to the connector of the
copier and then tighten the screws of the connector.
copier and then tighten the screws of the connector.
9. Remove the filament tape.
Remove the filament tape located in the positions shown in the illus-
tration.
tration.
10. Attach the intermediate tray.
Insert the intermediate tray all the way into the RSPF.
Insert the power plug of the copier to the outlet and turn on the main
switch of the copier.
switch of the copier.
11. Adjust the RSPF white correction pixel
Open the RSPF and execute SIM 63-7 to adjust the RSPF auto white
correction pixel.
correction pixel.
12. Check the copy magnification ratio.
Set an original on the document glass and copy it.
Then, set an original in the document feeder tray and copy it.
Then, set an original in the document feeder tray and copy it.
If the magnification ratio of the copy from the RSPF is different from
that of the copy from the document glass, carry out adjustment refer-
ring to the service manual.
that of the copy from the document glass, carry out adjustment refer-
ring to the service manual.
13. Check the center displacement.
Set an original on the document glass and copy it.
Then, set an original in the document feeder tray and copy it.
Then, set an original in the document feeder tray and copy it.
If the center of the copy image from the RSPF is different from that of
the copy image from the document glass, carry out adjustment refer-
ring to the service manual.
the copy image from the document glass, carry out adjustment refer-
ring to the service manual.
14. Check the top end position.
Set an original on the document glass and copy it.
Then, set an original in the document feeder tray and copy it.
Then, set an original in the document feeder tray and copy it.
If the top end position of the copy image from the RSPF is different
from that of the copy image from the document glass, carry out adjust-
ment referring to the service manual.
from that of the copy image from the document glass, carry out adjust-
ment referring to the service manual.
15. Check the open/close detection position.
If the open/close detection position measured with the open/close
detection position adjustment method described in the service manual
does not conform to the specifications, carry out adjustment referring
to the service manual.
detection position adjustment method described in the service manual
does not conform to the specifications, carry out adjustment referring
to the service manual.
Installation of RSPF is now complete.
Hinge
Screw
Screw
Filament tape
Intermediate tray
Click on the first or last page to see other AR-RP3 service manuals if exist.