Read Sharp AR-RP1 (serv.man2) Service Manual online
(4) OC (SPF) open/close detection position
adjustment
1) Set a paper of A4 (8.5 x 11") on the OC table.
Check that the document size display on the operation panel is the
same as the set paper size.
2) Close the OC (SPF) so that your hand can be inserted, and re-
move the paper on the OC table.
The document size display does not change from 1).
3) Gradually open the OC (SPF) until the display on the operation
panel is changed. Measure the distance (A) in the figure below
when the display on the operation panel is changed (all document
when the display on the operation panel is changed (all document
size lamps are turned OFF).
<Specifications>
OC (SPF) open/close position A : 207 ~ 302mm
4) If the OC (SPF) open/close position A is not 207 ~ 302mm, adjust
the open/close sensor installing plate position shown in the figure
below.
[7] DISASSEMBLY AND ASSEMBLY
1. External fitting section
(Note)
Turn the paw in the arrow direction.
2. Paper feed unit section
1) Paper feed unit
A
Open.
1) Check the position where the display checked in 1) is changed.
Distance (A) = Table glass top - OC (SPF) knob rib
(A)
(B)
Open/close sensor installing plate
Factory setting: The second top mark
Click on the first or last page to see other AR-RP1 (serv.man2) service manuals if exist.