Read Sharp AR-PK4 (serv.man5) FAQ online
FIRMWARE REVISION HISTORY
23rd July 2004
AR-C260M Print Controller (AR-P16N)
Boot
PCL
Revision Made
1.40 3.22
• Start of AB Production (UK Market)
• Corrects F9-00 trouble (communication driver error)
• Addresses corrupt characters when reduced printing is performed using
• Corrects F9-00 trouble (communication driver error)
• Addresses corrupt characters when reduced printing is performed using
Excel (long edge feed).
- 3.29
• Corrects corrupted test page 2/2 when performing “Easy Calibration” (Key
Operator)
1.50 3.65
• Supports AR-NS2 scanning (Push Scan Only)
• Corrects possible F9-00 trouble when Boot 1.40 firmware is installed onto
• Corrects possible F9-00 trouble when Boot 1.40 firmware is installed onto
first lot production board (Jan/Feb’03).
• When clearing Pre Heat mode, the set size paper was not selected
automatically even though the paper size was available (Desk Unit).
- 3.69
• Corrects a Black line that appears on the lead edge of all print jobs.
1.90
5.04
• Supports 500Mhz controller (AR-P16N).
• Supports 600DPI push scanning (Colour)
• Supports 600DPI push scanning (Colour)
• Supports Twain Scan (Pull)
• Unnecessary streaks appearing in gradation printing.
• Unnecessary streaks appearing in gradation printing.
Note: Engine firmware must be upgraded to v5 when upgrading the Print
Controller board to this version (or higher).
Controller board to this version (or higher).
-
5.17
• Supports AR-PK4 Postscript Option.
• When sending a job with the paper size specified to A3W via a driver, the
• When sending a job with the paper size specified to A3W via a driver, the
job will be deleted at the time when the state of LED changes from flashing
to staying illuminated.
to staying illuminated.
• When printing a job exceeding the staple capacity, the machine locks up at
the time when removing the job from the compiler.
• If paper out condition occurs during printing with staple function selected,
the machine may locks up after refilling with paper stock.
- 5.20
• In some cases, the machine failed to resume printing following a paper out,
paper jam or replace toner condition.
-
5.34
• Corrects failure to print after a scheduled e-mail status message has been
sent.
• Description of A3W is changed to 12x18 for all destinations.
• Supports Auto Colour Calibration for printer (enable using Sim 26-54).
• Supports Auto Colour Calibration for printer (enable using Sim 26-54).
POSTSCRIPT OPTION (MFP & PRINTER)
AR-PK4
PS3
Revision Made
0.37
• Start of UK Production
0.47
• Supports 4bit PS output
• Changed screening for improved performance and image quality
• Changed screening for improved performance and image quality
0.49
• Enable PS Screen change using Sim 67-29.
Click on the first or last page to see other AR-PK4 (serv.man5) service manuals if exist.