Read Sharp AR-PE3 (serv.man4) Service Manual online
12
Removing and replacing the Fiery X3e motherboard
Removing and replacing the Fiery X3e motherboard
When the Fiery X3e motherboard must be removed and replaced, use the following
procedures.
procedures.
T
O
REMOVE
THE
F
IERY
X3
E
MOTHERBOARD
C
AUTION
:
Wear an ESD grounding wrist strap and follow standard ESD (electrostatic
discharge) precautions while performing this procedure.
1.
Remove the Fiery X3e from the print engine as described on page 8.
2.
Disconnect the HDD cable from the PRIMARY IDE DRIVE connector.
3.
Disconnect the enclosed fan cable from motherboard ENC_FAN connector.
4.
Remove the screws securing the Fiery X3e motherboard to the pan (8) and faceplate (2).
F
IGURE
I
Motherboard and pan
5.
Pull up the motherboard from the pinch-pin stand-off. Make sure not to flex the
motherboard. Slide the motherboard away from the faceplate cutouts.
motherboard. Slide the motherboard away from the faceplate cutouts.
6.
Lift the motherboard out of the pan and set it on a flat anti-static surface.
As you remove it, avoid stressing the motherboard.
7.
If you are replacing the motherboard with a new motherboard, then remove the optional
DIMM (if present) from the old motherboard (see page 14).
DIMM (if present) from the old motherboard (see page 14).
Faceplate screw (1 of 2)
Pan screw (1 of 8)
ENC_FAN connector
PRIMARY IDE DRIVE connector
Enclosed fan
Pan
Click on the first or last page to see other AR-PE3 (serv.man4) service manuals if exist.