Read Sharp AR-PE2 (serv.man8) Parts Guide online
– 1 –
[1] OUTLINE
This unit is used to connect the printer controller with the scanner and
the printer section in the AR-C160.
the printer section in the AR-C160.
1. Unit composition
This unit is composed of the following major parts:
AR-PE2
• Controller
• I/F card
• Connection cable
AR-PX3/PX4
• Power supply unit
2. Outline of operations
(Printer mode)
Each color image data of 8bit of Y/M/C/K outputted from the print con-
troller.
troller.
(Scanner mode)
Each color image data of R/G/B scanned by the scanner is inputted to
the printer I/F card.
the printer I/F card.
(Circuit system)
High-speed data transmission/reception is performed between the en-
gine and the print controller.
gine and the print controller.
[2] SETUP
Necessary tools: Screwdriver
1. Unpacking
(Parts list)
AR-PE2
AR-PX3/PX4
2. Parts assembly
1) Remove the operation unit.
Left side
Right side
2) Remove the left and right upper cabinet.
3) Remove the ICU PWB shield plate.
4) Remove the CCD flat cable connector.
No.
Part name
Quantity
1
Controller
1
2
I/F card
1
3
Flat cable
1
4
Wake up harness
1
No.
Part name
Quantity
1
Power supply unit
1
2
Screw (M4)
8
3
Caution label (Only EU)
1
FOR USE WITH COMPATIBLE SHARP COPIERS.
SEE SHARP COPIER INSTALLATION MANUAL TO DETERMINE SUITABILITY.
AR-PE2/PX3/PX4 Installation Manual
Click on the first or last page to see other AR-PE2 (serv.man8) service manuals if exist.