AR-PE2 (serv.man6). AR-PE2 EFI Service Manual. - Sharp Copying Equipment Service Manual (repair manual). Page 9

 

The 

 

is intended for certified Fiery AR-PE2

 

™

 

 and copier service technicians 

servicing a Fiery AR-PE2. If you have not received installation and service certification, 
you should not attempt to service a Fiery AR-PE2. Electronics for Imaging, Inc. does not 
warrant the performance of the Fiery AR-PE2 if installed or serviced by non-certified 
personnel.

 

This guide is divided into the following sections:

• “Preface” 

Gives general information about this guide and general information that you should 
know before you attempt to service the Fiery AR-PE2.

• Chapter 1, “Introduction” 

Provides an overview of the Fiery AR-PE2.

• Chapter 2, “Using the copier Operation Panel” 

Tells you how to use the Fiery AR-PE2 Operation Panel for Fiery AR-PE2 
status/control functions. 

• Chapter 3, “Service Procedures”

Describes removal and replacement procedures for Fiery AR-PE2 board components, 
how to check connections, and how to reinstall system software.

• Chapter 4, “Troubleshooting Procedures”

Identifies the source of common problems and suggests ways of correcting them.

Customers should not use the technical service documentation. Do not leave this guide 
behind after you make a service call.

 

Illustrations in this guide reflect the Fiery AR-PE2 assembly at the time of publication. 
Components shown in these illustrations are subject to change. To receive information 
about any components that do not match illustrations in this guide, contact your 
authorized service support center.