AR-PE1 (serv.man9). AR-PE1 EFI Service Manual. - Sharp Copying Equipment Service Manual (repair manual). Page 11

 

The 

 

is intended for certified 

Print Controller X4(AR-PE1)

 

™

 

 and copier service technicians installing or servicing the 

Print Controller X4(AR-PE1) Color Server. If you have not received installation and 
service certification, you should not attempt to install or service the 
Print Controller X4(AR-PE1) Color Server. Electronics For Imaging does not warrant 
the performance if installed or serviced by non-certified personnel.

 

This guide is divided into the following topics:

• “Preface”

General information about this guide and about installing the 
Print Controller X4(AR-PE1)

• Chapter 1, “Introduction”

General information about the Print Controller X4(AR-PE1)

• Chapter 2, “Preparing for Installation”

Unpacking and steps to take before installing the unit

• Chapter 3, “Connecting the Print Controller X4(AR-PE1)”

Connect the Print Controller X4(AR-PE1) to the copier and the network, and 
verifying that the system is working correctly; overview of the Control Panel

• Chapter 4, “Service Procedures”

Removal and replacement procedures for Print Controller X4(AR-PE1) components

• Chapter 5, “Troubleshooting”

Common problems and their solutions; startup error codes

 

Print Controller X4(AR-PE1) customers should not use the technical service 

documentation. Please don’t leave your copy of the 

 

behind 

after you make a service call.

 

The illustrations in this guide reflect the current shipping version of the 
Print Controller X4(AR-PE1) at the time of publication. Components shown in these 
illustrations are subject to change. To receive information about any 
Print Controller X4(AR-PE1) components that do not match the illustrations in this 
guide, contact your authorized service/support center.