Read Sharp AR-P350 / AR-P450 (serv.man25) FAQ online
Page 5 of 6
Press the “Back/C” Key.
Press the “Menu” Key 15 times.
The display should read “MNT CYCLE SET”.
Press the “OK” Key.
Use the UP/Down Arrows to change the value to the one shown on the chart.
Press the “OK” Key to set the new value into memory.
Press the “Back/C” Key.
The display should read “MNT CYCLE SET”.
Press the “OK” Key.
Use the UP/Down Arrows to change the value to the one shown on the chart.
Press the “OK” Key to set the new value into memory.
Press the “Back/C” Key.
Press the “Menu” Key 1 time.
The display should read “LIFE OVER SETTING”.
Press the “OK” Key.
Use the UP/Down Arrows to change the value to the one shown on the chart.
Press the “OK” Key to set the new value into memory.
The display should read “LIFE OVER SETTING”.
Press the “OK” Key.
Use the UP/Down Arrows to change the value to the one shown on the chart.
Press the “OK” Key to set the new value into memory.
Press the “Menu” Key 9 times.
The display should read “PROCESS SETTING”.
Press the “OK” Key.
Use the UP/Down Arrows to change the value to the one shown on the chart.
Press the “OK” Key to set the new value into memory.
The display should read “PROCESS SETTING”.
Press the “OK” Key.
Use the UP/Down Arrows to change the value to the one shown on the chart.
Press the “OK” Key to set the new value into memory.
Press the “Back/C” Key.
Turn the machine Off/On.
Turn the machine Off/On.
3)
The 100K Drum (AR-451DR) must be installed in the machine.
The AR-451DR can be identified by a white mark on the rear side flange
and by the aluminum base being slightly exposed on the front side as
shown in the pictures below.
The AR-451DR can be identified by a white mark on the rear side flange
and by the aluminum base being slightly exposed on the front side as
shown in the pictures below.
Click on the first or last page to see other AR-P350 / AR-P450 (serv.man25) service manuals if exist.