AR-NC3D (serv.man4). ARNC1D 3D Operation Manual - Sharp Copying Equipment User Guide / Operation Manual. Page 14

 

Hardware Installation-3

 

Use the following procedures to power up the printer. Do this before the printer is 
attached to the network to verify the physical installation of the Print Server Card. 
1. Plug in the power cord.
2. Turn on the power and wait for the printer to warm up. The printer may print out a 

status or start-up page (if this option is not disabled). The Print Server Card then 

provides a print job to the printer which contains the Print Server Card status 

information. Refer to 

 

 for more information.

3. Check the Print Server Card status report. Record the serial number and the Net-

work address or save the status report. This information will be needed when  con-

figuring the printer for your network.

Refer to one or more of the following chapters for instructions on configuring the net-
work for the Print Server Card. 
•  Chapter 4: Novell NetWare Configuration
•  Chapter 5: Windows Peer-To-Peer Configuration
•  Chapter 6: AppleTalk Configuration
•  Chapter 7: TCP/IP Configuration