Read Sharp AR-NC3D (serv.man22) Technical Bulletin online
Sharp Electronics (UK) Ltd., NIS Systems Support
NIS Bulletin 008.doc
Page: 4 of 7
7. Now that the Printer Driver has been installed we need to setup the printer port.
Click the down arrow next to the Print To selection and scroll down to port required. If the
ARPB2/+ is to be connected directly to the back of the NT server or workstation using a parallel
cable, select an appropriate LPT Port.
ARPB2/+ is to be connected directly to the back of the NT server or workstation using a parallel
cable, select an appropriate LPT Port.
If a network card is installed and you want to print to the copier across a network, scroll down to
Other at the bottom of the Print To list.
Other at the bottom of the Print To list.
8.
Click Other and the following list of available ports will appear. As with a Windows NT4
installation we now need to select an LPR Port.
installation we now need to select an LPR Port.
If the LPR Port is not listed, the TCP/IP Printing Service is not installed. To install the TCP/IP
Printing Service, go to the Control Panel/Network settings.
Printing Service, go to the Control Panel/Network settings.
Click Add Software from within Control Panel/Networks and select the TCP/IP Protocol and
related components as seen below. If the TCP/IP protocol had not already been installed, the
protocol will require configuring on the server. If this service has to be installed, the Windows
NT3.51 Disks will be required, and the file server will require rebooting.
related components as seen below. If the TCP/IP protocol had not already been installed, the
protocol will require configuring on the server. If this service has to be installed, the Windows
NT3.51 Disks will be required, and the file server will require rebooting.
Click on the first or last page to see other AR-NC3D (serv.man22) service manuals if exist.