AR-NB3 (serv.man10). ARNB3 (Network Printing Operation Manual) for when installed on AR-M165 or AR-M207. - Sharp Copying Equipment User Guide / Operation Manual. Page 5

Printing begins.
The print job is delivered to the output tray, with 
the position of the paper offset slightly from the 
previous job (offset function).

Add paper to the tray that ran out or to the bypass tray. If you add paper to the bypass tray, press the [PRINT] key on 
the machine to switch to printer mode and select "BYPASS-TRAY". Printing will resume. Note that if the "AUTO 
TRAY SWITCHING" setting is selected in the "PAPER SIZE SET" (accessed by pressing the [SPECIAL 
FUNCTION] key) and there is the same size of paper in another tray, the machine will automatically switch to the 
other tray and continue printing.

To pause a print job, press the [PRINT] key on the machine to switch to printer mode and then select "OFFLINE" 
with the [

] key. The machine pauses the print job and then goes offline.

• To cancel a print job, press the [C] key (

).

• To resume printing, select "ONLINE" with the [

] key.

If "Paper Source" is set to [Auto Select] in the [Paper] tab of the printer driver setup screen and the correct size of 
paper for a print job is not loaded in the machine, the printing procedure will vary depending on the "FORCED 
OUTPUT OF PRINT" setting 

 in the key operator programs.

When "FORCED OUTPUT OF PRINT" is disabled

Add paper to the bypass tray, press the [PRINT] key on the machine to switch to printer mode, and select 
"BYPASS-TRAY". Printing will resume.

When "FORCED OUTPUT OF PRINT" is enabled

The closest size of paper in a tray other than the bypass tray will be used for printing.

There are two bypass tray settings in "Paper Source" in the [Paper] tab of the printer driver setup screen:

• When [Bypass Tray] is selected, the print job is automatically printed on the paper in the bypass tray.
• When [Bypass Manual] is selected, the print job is not printed until paper is inserted into the bypass tray. If paper 

is already in the bypass tray, remove the paper and then re-insert it to begin printing.

The output tray can be selected when 
selecting print settings at the time of 
printing. To change the tray selection, select 
the desired tray in "Output" in the [Paper] 
tab of the printer driver setup screen.

If the print image is in a different orientation than the paper, the print image will be automatically rotated 90 
degrees to enable correct printing on the paper. (Other than the bypass tray)