AR-M550 (serv.man28). ARM550 620-Operation Manual (Copy) - Sharp Copying Equipment User Guide / Operation Manual. Page 71

When loading paper in the inserter, load the paper face up. If the paper has a top edge and bottom edge, load in
the same top-bottom orientation as the original. Adjust the paper guide on the paper tray to the width of the paper.
When using tabbed paper, place the paper as follows:

Load the paper back
side up. 
The top side is
inserted first.

The relation of copies and tabbed sheets is shown below.

The inserter can be used for stapling or punching without performing a copy operation. These functions are selected
at the operation panel of the inserter.

[PUNCH] key
When a punch module is installed on the finisher
or saddle stitch finisher, punch holes can be
added to blank paper or printed paper. The
indicator lights when this function is selected.
[STAPLE] key/indicator
When this function is selected, each set of output
is stapled and delivered to the finisher or saddle
stitch finisher tray. (Note that the sets are not
offset.) Press this key until the icon light of the
desired staple position lights up. ("

" pamphlet

stapling can only be selected when a saddle stitch
finisher is installed)

[START] key/indicator
After selecting punch or staple settings with key

 or key 

, place the paper to be punched or

stapled on the inserter tray and press this key.

Back side

Inserted first.

Back
side

1st sheet

4th sheet

1st sheet

Back
side

2nd sheet

3rd sheet

4th sheet

5th sheet

Back
side

Tabbed paper 4th sheet (back side)

Tabbed paper 1st sheet (back side)

5th sheet

Back
side

1

2

3

1

2

NOTES
● Do not use tabbed paper when operating the inserter manually.
● The punching and stapling functions cannot be used when the finisher or saddle stitch finisher has failed, or

when the functions are prohibited* in the key operator programs (page 11 of the key operator's guide).
* Disabling of stapler/Disabling of punch/Disabling of finisher/Disabling of inserter