Read Sharp AR-M550 (serv.man23) Service Manual online
AR-M550/M620 INSTALLATION MANUAL (AR-LC6) 2 - 8
3) Then pull out the paper feed tray again until it stops.
[When shifted to the front side]
When shifting the print line from the paper center in the arrow direction
as shown below:
as shown below:
4) Loosen the red fixing screws (2 pcs. for each) of the front/back size
guide adjustment plate, and slide the side guide adjustment plate
in the direction A (R side) by the shift dimension. Tighten the red
fixing screws (2 pcs. for each). Slide the auxiliary guide in the
direction of A by the same dimension.
in the direction A (R side) by the shift dimension. Tighten the red
fixing screws (2 pcs. for each). Slide the auxiliary guide in the
direction of A by the same dimension.
Then push the paper feed tray into the machine, and return the
stopper to the original position, and fix it with the fixing screw (1 pc.).
stopper to the original position, and fix it with the fixing screw (1 pc.).
At that time, check that the stopper pawl is engaged with the stop-
per receiver of the large capacity tray.
per receiver of the large capacity tray.
5) Push the large capacity tray to the original position slowly.
Then make a copy again to check that the center is not shifted. Repeat
this procedure as required.
this procedure as required.
[When shifted to the rear side]
When shifting the print line from the paper center in the arrow direction
as shown below:
as shown below:
4) Loosen the red fixing screws (2 pcs. for each) of the front/back size
guide adjustment plate, and slide the side guide adjustment plate
in the direction B (F side) by the shift dimension. Tighten the red
fixing screws (2 pcs. for each), and push the paper feed tray into
the machine. Return the stopper to the original position, and fix it
with the fixing screw (1 pc.). Slide the auxiliary guide in the direc-
tion of B by the same dimension.
in the direction B (F side) by the shift dimension. Tighten the red
fixing screws (2 pcs. for each), and push the paper feed tray into
the machine. Return the stopper to the original position, and fix it
with the fixing screw (1 pc.). Slide the auxiliary guide in the direc-
tion of B by the same dimension.
At that time, check that the stopper pawl is engaged with the stop-
per receiver of the large capacity tray.
per receiver of the large capacity tray.
5) Push the large capacity tray slowly into the original position.
Then make a copy again to check that the center is not shifted. Repeat
this procedure as required.
this procedure as required.
A
R side
F side
B
R side
F side
Click on the first or last page to see other AR-M550 (serv.man23) service manuals if exist.