AR-M550 (serv.man124). 023-Prevention of POD1_N misfeeds due to the paper caught on the drum separator pawl section. - Sharp Copying Equipment Technical Bulletin (repair manual). Page 4

Read Sharp AR-M550 (serv.man124) Technical Bulletin online

Sharp Electronics (UK) Ltd., Technical Services Group
ARE666
7.  After inserting the SP pin till it protrudes to one side insert the separator pawl shaft
pick and refit the E type ring, this process is repeated four times.
8.  Insert the separator pawl shaft in the reverse procedure as when removing, (note the
separator pawl shaft is to be set with it’s face up).
9.  Remove the screw of the separator pawl waver bearing B, and slide the separator
pawl waver bearing B to the front side.
10.  When the separator pawl waver bearing B has slid to the front side faace the
separator pawl shaft pick facing down. Be sure to insert the boss portion of the
separator pawl pick to the inside of the separator pawl holder.
11.  Restore the separator pawl waver bearing B as before and fix it by the screw.
12.  Assemble by following the procedure from Number 1 to Number 4 in reverse order.
Page of 4
Display

Download Sharp AR-M550 (serv.man124) Technical Bulletin