AR-M256 (serv.man19). Key Operator's Guide - Sharp Copying Equipment User Guide / Operation Manual. Page 21

This program must be enabled to use the machine on 
a network that uses EtherTalk protocol.
This program is initially enabled (factory default setting).

This program must be enabled to use the machine on 
a network that uses NetBEUI protocol.
This program is initially enabled (factory default 
setting).

This program is used to restore all network settings to 
the factory default settings.

These programs are used to return the configuration 
settings (See the online manual for network printer) 
and the "PRINT SETTINGS" (p.16) to the factory 
default settings. The programs are also used to store 
the current settings and to restore stored settings.
"INITIALISE AND/OR STORE SETTINGS" consists of 
the following programs:

● RESTORE FACTORY DEFAULTS

● STORE CURRENT CONFIGURATION

● RESTORE CONFIGURATION

This program is used to return the configuration 
settings (see the online manual for network printer) 
and the "PRINT SETTINGS" (p.16) to the factory 
default settings. If you need a record of the current 
settings before restoring the factory defaults, use 
"Data list print" in the user settings to print a list of the 
current settings. (See "CUSTOM SETTINGS" in the 
operation manual for copier.)

This program is used to store the current configuration 
settings (see online manual for network printer) and 
"PRINT SETTINGS" (p.16). The stored settings will not 
be erased even if the power is turned off. To restore 
the stored settings, use the "RESTORE 
CONFIGURATION" program.

This program is used to restore settings that were 
stored using the "STORE CURRENT 
CONFIGURATION" program.
The current settings will change to the restored 
settings.

Some programs in the following are marked 
by "*1". This indicates that a message will 
appear at the end of the setting procedure 
asking you to confirm execution of the new 
setting. If needed, you can cancel the new 
setting by touching the [NO] key.

If any of the "NETWORK SETTINGS" (p.18) 
were changed before execution of this 
program, you must turn off the machine’s 
power switch, wait briefly, and then turn the 
switch back on in order to make the settings 
take effect.

AR-M318_keyope_uk.book  19 ページ  ２００７年１月１１日　木曜日　午後２時４４分