Read Sharp AR-M236 (serv.man11) User Guide / Operation Manual online
12
GENERAL PROGRAMS
STREAM FEEDING MODE
Use this program to enable stream feeding mode.
When this mode is enabled and originals are scanned
from the REVERSING SINGLE PASS FEEDER, an
original can be added to the REVERSING SINGLE
PASS FEEDER within 5 seconds after the previous
original is fed, and be automatically scanned using the
settings of the previous original. This function can be
used with the copy function and the scanner function.
When this mode is enabled and originals are scanned
from the REVERSING SINGLE PASS FEEDER, an
original can be added to the REVERSING SINGLE
PASS FEEDER within 5 seconds after the previous
original is fed, and be automatically scanned using the
settings of the previous original. This function can be
used with the copy function and the scanner function.
DISPLAY LANGUAGE SETTING
This program is used to change the language used in
the display.
the display.
DISABLE DISPLAY TIMEOUT
When this program is disabled, the display will close
the screen that is currently open and return to the
initial screen if no keys are touched for 60 seconds.
When the program is enabled, the display will not
close the screen that is currently open.
the screen that is currently open and return to the
initial screen if no keys are touched for 60 seconds.
When the program is enabled, the display will not
close the screen that is currently open.
DISABLING OF TRAY SETTINGS
This program can be enabled to prohibit changes to
the tray settings. Note that bypass tray settings will still
be possible.
the tray settings. Note that bypass tray settings will still
be possible.
DEVICE CONTROL
Use these programs when a peripheral device on the
machine has failed or when you wish to temporarily
disable a device. The programs can also be used to
change the function setting of a device as required by
your conditions of use.
"DEVICE CONTROL" consists of the following
programs:
machine has failed or when you wish to temporarily
disable a device. The programs can also be used to
change the function setting of a device as required by
your conditions of use.
"DEVICE CONTROL" consists of the following
programs:
●
DISABLING OF DOCUMENT FEEDER
●
DISABLING OF DUPLEX
●
DISABLING OF STAPLER
●
OUTPUT TRAYS
●
OFFSET FUNCTION SETTING
●
MEMORY FOR PRINTER
●
DISABLING OF CENTER TRAY COUNTING
●
RETURN FROM COPY MODE TIMING
●
MIX SIZE ORIGINAL FEEDING MODE
DISABLING OF DOCUMENT FEEDER
Use this program when the REVERSING SINGLE
PASS FEEDER has failed or you wish to disable the
automatic feeding function. (Originals can still be
scanned using the document glass.)
PASS FEEDER has failed or you wish to disable the
automatic feeding function. (Originals can still be
scanned using the document glass.)
DISABLING OF DUPLEX
Use this program when you wish to disable the
two-sided printing function or the function has failed.
When this program is enabled, only one-sided printing
is possible.
two-sided printing function or the function has failed.
When this program is enabled, only one-sided printing
is possible.
DISABLING OF STAPLER
(When a FINISHER is installed)
Use this program to disable stapling.
When this program is enabled, stapling does not take
place.
When this program is enabled, stapling does not take
place.
KEY OPERATOR PROGRAMS
DEVICE CONTROL
DISABLING OF DUPLEX
DISABLING OF STAPLER
DISABLING OF DOCUMENT
FEEDER
FEEDER
OK
1/3
Click on the first or last page to see other AR-M236 (serv.man11) service manuals if exist.