Read Sharp AR-FN7 Service Manual online
AR-FN7/PN1 UNPACKING AND INSTALLATION-6
<3>Install the front cabinet to the original position, push the staple unit
into the machine, and fix it with four fixing screws.
*
When installing, insert the projection (B) of the lock release lever into
the latch arm hole (C).
*
After installation, release the latch and move the lever to check that it
slides smoothly.
*
If it does not move smoothly, disengage the pawl on the lower side of
the release lever with a screwdriver (-) and remove the lever. Then
the release lever with a screwdriver (-) and remove the lever. Then
insert is again.
<4>Install the jam process dial, and close the front cover.
8) Install the right front cover of the finisher.
<1>Install the front cover with four fixing screws.
<1>Install the front cover with four fixing screws.
<2>Install the stand cover with three fixing screws, and install the sub
cover with one fixing screw.
9) Attach the dust box label to the upper cover.
<1>Attach the dust box cover to the position shown in the figure below.
10) Connect the connector to the paper feed desk, and connect the AC
cord of the power unit to the printer.
<1>Connect the connector of the interface harness of the finisher to the
paper feed desk, and tighten the connector fixing screw.
<2>Connect the AC cord of the power unit to the inlet connector of the
printer as shown in the figure.
11) Turn on the main switch of the printer.
<1>Insert the power plug of the printer to the power outlet.
<2>Turn on the main switch of the printer.
3
Staple unit
Front cabinet
Fixing screw
Fixing screw
Latch arm
Pawl (D)
Lock release lever (A)
Projection (B)
Jam process dial
Front cover
Fixing screw
Fixing screw
Stand cover
Sub cover
Fixing screw
Fixing screw
Fixing screw
Fixing screw
AC cord
Connector
Fixing screw
"ON"
, ! #$! %&'(
Click on the first or last page to see other AR-FN7 service manuals if exist.