Read Sharp AR-FN7 Service Manual online
5-6
CHAPTER 5 TROUBLESHOOTING
COPYRIGHT © 2001 CANON INC.
2000 2000 2000 2000
CANON SADDLE FINISHER G1 REV.0 MAR. 2001
ON
1
2
3
4
1.2.4 After Replacing the EEP-ROM (IC1002)
1) Turn off the host machine.
2) Set bits 1 through 4 on the punch controller PCB as follows:
2) Set bits 1 through 4 on the punch controller PCB as follows:
F05-102-03
3) Press SW1002 and SW1003 on the punch controller PCB at the same time.
•
•
The presses will initialize the EEP-ROM. At the end, all LEDs (LED1001, LED1002,
LED1003) will go ON.
LED1003) will go ON.
4) Adjust the sensor output, and store the number of punch holes.
Chap05.p65
3/28/01, 12:11 PM
6
Click on the first or last page to see other AR-FN7 service manuals if exist.