Read Sharp AR-FN1 (serv.man6) Service Manual online
[Reinstalling elevator wires (top, bottom) at the front
frame side]
frame side]
1) Insert both the top elevator wire 15) and bottom elevator wire 16)
into the elevator pulley drive shaft A. Secure the winding pulley
18) with the screw 17).
18) with the screw 17).
2) Hook the bottom elevator wire 16) on the lower wire roller B from
the left side of the winding pulley 18), without giving extra winding.
With the wire extended upward, hook the wire mounting spring 14)
on the wire hook.
With the wire extended upward, hook the wire mounting spring 14)
on the wire hook.
3) Wind the top elevator wire 15) onto the winding pulley 18) 3 and
3/4 turns in the clockwise direction, and hook on the upper wire
roller C. Hold it stretched downward.
roller C. Hold it stretched downward.
4) When setting the top and bottom elevator wires at the rear frame
side (see the sketch below), observe the following conditions:
[Note] Observe the following conditions when setting elevator-wires
(top and bottom) at the rear frame side. See the sketch below.
•
The bottom elevator wire 16) should be hooked onto the
bottom wire roller B from the right side of the winding pulley
18) without giving extra winding.
bottom wire roller B from the right side of the winding pulley
18) without giving extra winding.
•
The top elevator wire 15) should be wound onto the winding
pulley 18) 3 and 3/4 turns in the counterclockwise direction.
pulley 18) 3 and 3/4 turns in the counterclockwise direction.
10. Paper discharge roller 3
10-1. Paper discharge roller 3 (top)
15)
16)
17)
18)
A
B
C
14)
2)
5)
2)
1)
1)
3)
4)
6)
5)
5)
5)
4)
7)
7)
9)
9)
10)
8)
5 – 7
Click on the first or last page to see other AR-FN1 (serv.man6) service manuals if exist.