AR-F151 (serv.man16). AR-F151-Operation Manual - Sharp Copying Equipment User Guide / Operation Manual. Page 2

WARNING NOTICE:
NO calls can be made to or from this fax during a mains power failure.

WARNING — Australian Communications Authority (ACA) regulations state that no
unauthorised changes or modifications to this equipment are permitted.

Note: Complies with the following standards,

ACA TS001-1997, AS/NZS 3260
ACA TS002-1997 and AS/NZS 3548.

These limits are designed to provide reasonable protection against interference in an
installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause interference. However,
there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

— Reorient or relocate the receiving antenna.

— Increase the separation between the equipment and the receiver.

— Connect the equipment to an outlet on a different circuit to that which the receiver is

connected.

— Consult the dealer or an experienced radio/TV technician for help.

The Ringer Equivalence Number (REN) for this equipment is written on the A-Tick label.

Installing or modifying telephone lines should only be done by an ACA licensed serviceman.

Note: In some areas a distinctive ring pattern can be provided by the telephone

companies for modems. The fax cannot use the distinctive ring pattern that is in use
for the modem.

00_1_telephone _sistemSCA.p65

3/22/00, 2:39 PM

2