AR-D34. Service Manual. - Sharp Copying Equipment Service Manual (repair manual). Page 5

AR-D35/D34 ADJUSTMENT

– 4 –

Follow these steps to change a tray’s paper size setting.

Note:

•  The paper size setting cannot be changed when the machine has

stopped temporarily due to running out of paper or a misfeed, or
during interrupt copying.

•  During printing (even in copy mode), the paper size setting cannot

be changed.

•  A5(5-1/2” x 8-1/2”) size paper can only be selected in upper paper

tray.

•  Do not load paper that is a different size than the paper size set-

ting. Copying will not be possible.

1) Hold down the [TRAY SETTING] key for more than 5 seconds to set

the selected paper size.

The currently selected paper feed location indicator will blink and
the corresponding paper size (which is currently set) indicator will
light steadily. All other indicators will go out.

2) If the machine has two or more paper trays, use the [PAPER

SELECT] key to select the paper tray for which you wish to change
the paper size setting.

Each time the [PAPER SELECT] key is pressed, a paper tray will be
indicated with a blinking paper feed location indicator.

3) Use the [ORIGINAL] key to select the paper size.

The indicator of the selected paper size lights up.

4) Squeeze the lock lever of the front guide and slide the front guide to

match the width of the paper, and move the left guide to the appro-
priate slot as marked on the tray.

• The front guide is a slide-type guide. Grasp the locking knob on

the guide and slide the guide to the indicator line of the paper to
be loaded.

•  The left guide is an insert-type guide. Remove it and then insert it

at the indicator line of the paper to be loaded.

• When using 11” x 17” sized paper store the left guide in the slot

at the left front of the paper tray.

5) Press the [START] key and then the [TRAY SETTING] key.

To change the paper size setting of another tray, repeat steps 2 to 5
after pressing the [START] key.

Note: Affix the paper size label for the paper size selected in step 3 to

the label position on the right end of the tray.

Left guide

Front guide