Read Sharp AR-D17-19 (serv.man2) Service Manual online
AR-D17/D18/D19 UNPACKING AND INSTALLATION 2 - 2
6) Pull out to remove the No. 2 paper tray guide stopper in the direc-
tion of the arrow.
7) Pull out the No. 2 paper tray until it stops.
8) Pull out the No. 3 paper tray a little bit.
9) Pull out to remove the No. 3 paper tray guide stopper in the direc-
tion of the arrow.
2. Installation
Before installation
• Start installation after checking that the DATA indicator on the oper-
ation panel is neither lit nor blinking.
• For installation of the stand/two paper drawers with a duplex module
(AR-D19), the duplex bypass/inverter unit (AR-RB1) is always
needed.
needed.
Parts included
(1) Turn off the main switch of the main unit.
1) Turn the main switch located on the left side of the main unit to the
“OFF” position.
2) Then remove the power plug of the main unit from the outlet.
(2) Place the main unit on the optional stand.
(Note: This work must be performed by two
persons or more.)
persons or more.)
1) Pull out the four handles on the right and left sides of the main unit.
2) Place the main unit on the optional stand aligning the outside lines
(front side, right and left sides) of the main unit with those of the
stand.
stand.
Note: At this time, be careful not to hit the paper guide or the exte-
rior of the optional stand with the four rubber feet of the main
unit.
unit.
3) Ensure that the two positioning pins located on the top surface of
the optional stand are inserted securely into the positioning holes.
Connecting plate:
2 pcs.
Connecting plate
cover: 2 pcs.
Connecting screw:
5 pcs.
“OFF”
Positioning pins
Paper guide
Handles
Handles
Click on the first or last page to see other AR-D17-19 (serv.man2) service manuals if exist.