Read Sharp AR-C262M (serv.man3) Service Manual online
AR-C262M SETTING AND ADJUSTMENTS 8 - 9
There are two methods of the image registration adjustment: the
manual adjustment and the automatic adjustment. Either of them
uses the simulation.
manual adjustment and the automatic adjustment. Either of them
uses the simulation.
This adjustment is required in the following cases:
• When the scanner (writing) unit is replaced.
• When the scanner (writing) unit is removed from the machine.
• When color image mis-resist is generated in the main scanning
direction.
• When color image mis-resist is generated in the sub scanning
direction.
• When installation or the installing place is changed.
• When maintenance is performed. (When the OPC drum, the
photoconductor cartridge, the transfer unit, or the transfer belt is
replaced.)
replaced.)
• When U2 trouble occurs.
• When ICU PWB is replaced.
• When EEPROM on ICU PWB is replaced.
Remark: Though SIM 50-22 is not performed under the following
conditions, the image registration adjustment is per-
formed automatically.
formed automatically.
∗
When the toner cartridge is replaced.
∗
At every 8,000 copies (total of print quantity and copy quantity)
(When 8,000 copies is reached during a job, the machine stops
after completion of the job.)
(When 8,000 copies is reached during a job, the machine stops
after completion of the job.)
If the set item AR of SIM 44-1 is set to OFF (Disable), the above
operation is not performed.
operation is not performed.
After setting the image registration to the best by SIM 50-20, when
the image registration adjustment is automatically performed, the
best-adjusted condition may be varied. To avoid this, set the item
AR of SIM 44-1 to OFF (Disable).
the image registration adjustment is automatically performed, the
best-adjusted condition may be varied. To avoid this, set the item
AR of SIM 44-1 to OFF (Disable).
Note:
Before executing this adjustment, check that the following adjust-
ments have been properly completed.
ments have been properly completed.
∗
Print engine image focus adjustment (Scanner (writing) unit)
∗
Print engine image skew adjustment (Scanner (writing) unit)
∗
Image registration sensor adjustment
∗
SIM 48-6 FSM (Fuser roller speed) is set to the default.
Default setup of SIM 48-6 FSM (Fuser roller speed)
D: 80 (For paper of 420mm or shorter in the transport direction)
I: 85 (For paper of 420mm or longer in the transport direction)
J: 85
K: 70
This adjustment is used to perform the image registration adjust-
ment in the main scanning direction and in the sub scanning direc-
tion at the same time with the simulation.
ment in the main scanning direction and in the sub scanning direc-
tion at the same time with the simulation.
1) Enter the SIM 50-22 mode.
SIM 50-22
2) Press the [EXECUTE] key.
The [EXECUTE] key is highlighted, and the image registration
automatic adjustment is started. After completion of the adjust-
ment, the [EXECUTE] key returns to the normal display.
automatic adjustment is started. After completion of the adjust-
ment, the [EXECUTE] key returns to the normal display.
The adjustment process status is indicated with (
∗
) mark. It
takes several minutes to complete the adjustment.
3) Enter the SIM 50-20 mode.
SIM 50-20
4) Select the A4 (11 x 8 1/2) size paper feed tray.
5) Press the [EXECUTE] key.
The image registration adjustment pattern is printed.
ADJ 4
Image registration adjustment
ADJ 4A
Image registration adjustment
(Auto adjustment)
(Auto adjustment)
Click on the first or last page to see other AR-C262M (serv.man3) service manuals if exist.