Read Sharp AR-C200P (serv.man5) Service Manual online
114 /
Table 5-1-1 Operator Alarm (4/6)
Message
Cause
Error Description
Solutions
Service Call
160: Y Toner
161: M Toner
162: C Toner
163: K Toner
Service Call
170: Error
171: Error
174: Error
175: Error
Service Call
172: Error
176: Error
Service Call
173: Error
177: Error
Service Call
179: Error
Service Call
180: Error
~
186: Error
Service Call
187: Error
Close cover
310: Top
cover open
Reset fuser
320: Fuser
error
Turn power
OFF and wait
321: MOTOR
OVERHEAT
Open/close
cover
323: Paper
thickness
error
Open/close
cover
324: Paper
thickness
error
Open/close
cover
325: Paper
thickness
error
Open/close
cover
326: Paper
thickness
error
Error detected by toner
sensor.
Short circuit in fuser
thermistor or open
detected (high temp.
or low temp.)
Thermistor indicates
high-temperature error.
Thermistor indicates
low-temperature error.
Wrong fuser standard.
Communication
disability with option
unit detected by engine.
Communication with
control panel disabled.
Printer engine cover
open.
Same unit not detected
upon power ON or
opening cover.
Printer cannot be used
temporarily due to
motor overheat.
Sensor output out of
range with no media.
(Only for Factory Mode)
Sensor output gap out
of range with no media.
(Only for Factory Mode)
Media detect value out
of range.
U-Heavy mode media
detect value out of
range.
1) Is error message displayed?
2) Does error reoccur?
1) Is error message displayed?
2) Does error reoccur?
1) Is error message displayed?
2) Does error reoccur?
1) Is error message displayed?
2) Does error reoccur?
1) Does fuser match with model and power
voltage?
2) Error reoccurs after setting fuser properly.
1) Is error message displayed?
2) Does error reoccur?
Is cable properly connected to control panel?
1) Check if top cover is open.
2) Check if cover switch is proper.
1) Is error message displayed?
2) Is fuser unit set properly?
3) Does error reoccur?
1) Are foreign objects mixed in sensor?
2) Does printer recover when detecting
paper thickness by opening/closing tray?
3) Does printer recover by power OFF/ON.
1) Are foreign objects mixed in sensor?
2) Does printer recover when detecting
paper thickness by opening/closing tray?
3) Does printer recover by power OFF/ON.
1) Is different media type mixed in?
2) Is media being double fed?
Is different media type mixed in?
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
No
Yes
No
Yes
Yes
No
Yes
No
Yes
Yes
Replace toner sensor or assembly
(Y71-PWB).
Same as above.
Turn ON power again.
Replace thermistor and turn power
OFF. Leave aside for 30 min.
Turn ON power again.
Replace thermistor and turn power
OFF. Leave aside for 30 min.
Turn ON power again.
Replace thermistor and turn power
OFF. Leave aside for 30 min.
Set proper fuser.
Check if fuser is set properly.
Replace fuser.
Turn ON power again.
Replace option unit.
Connect properly.
Replace control panel and cable.
Close top cover.
Close side cover.
Replace cover switch.
Check if fuser is set properly.
Reset fuser and turn ON power again.
Replace fuser unit assembly.
Turn ON power after a while.
Remove foreign objects.
Normal.
Remove foreign objects.
Normal.
Remove foreign objects.
Remove foreign objects.
Click on the first or last page to see other AR-C200P (serv.man5) service manuals if exist.