AR-C200P (serv.man3). Handy guide - Sharp Copying Equipment Handy Guide. Page 25

Read Sharp AR-C200P (serv.man3) Handy Guide online

 
Message
Cause
Error Description
Solutions
Service Call
042: Error
~
044: Error
Service Call
048: Error
Service Call
049: Error
Service Call
050: Error
Service Call
051: Error
Service Call
063: Error
Service Call
065: Error
Service Call
070: Error
Service Call
072: Error
Service Call
073: Error
~
075: Error
Service Call
102: Error
Service Call
103: Error
Service Call
104: Error
Service Call
105: Error
Service Call
106: Error
Service Call
107: Error
Flash File SYSTEM
Error
CU ROM for PS+PCL
was set in Non-PS
device.
CU type mismatch
CU ROM does not
match with the device.
Operater Panel Error
CU Fan Error
Abnormal CPU cooling
fan on CU board.
Network comm. Error
Abnormal H/W I/F
between CU-NIC.
NIC Combination Error
CANT_HAPPEN
PS firmware fault
detected.
Engine communication
error I/F error between
PU-CU.
Video overrun detect
Error in engine RAM
read/write detected at
power ON.
Error in engine SRAM
read/write detected at
power ON.
Error in engine
EEPROM check total
detected at power ON.
EEPROM not detected
at power ON.
Error in engine control
logic detected at power
ON.
Engine ROM
check sum error.
Failed access to Flash set directly on CU
board.
Is proper program ROM set?
Is proper program ROM set?
Does error display reappear?
Is connector set properly on CU board?
Is error recovered by replacing fan?
Is network board set properly?
Is error recovered by replacing network
board?
Is proper Network board for the model set?
Confirm that error is recovered by turning
power OFF/ON.
Is CU assembly set properly?
Is error recovered by replacing TIG board?
Is CU assembly set properly?
Is error recovered by replacing TIG board?
Does error reoccur?
Does error reoccur?
Does error reoccur?
Does EEPROM exist?
Does error reoccur?
Does error reoccur?
Does error reoccur?
Is error recovered by reloading PU F/W?
Yes
No
Yes
No
Yes
No
Yes
No
No
Yes
No
Yes
No
No
No
Yes
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Press
)
,
3
,
5
,
6
 to turn power ON,
release buttons when
[FLASH FORMAT] appears, wait until
[ON-LINE] (2sec) and replace TIG
board if symptom does not change.
Replace program ROM DIMM.
Replace with proper program ROM
DIMM.
Replace program ROM DIMM.
Replace with proper program ROM
DIMM.
Refer to  no LCD display  flow chart.
Connect properly.
Replace fan.
Replace TIG board.
(Replace EEPROM.)
Set properly.
Replace Network.
Replace TIG board.
(Replace EEPROM.)
Replace NIC card.
Replace with proper Network board
(MLETB11, etc.).
Replace TIG board.
(Replace EEPROM.)
Set properly.
Replace TIG board.
(Replace EEPROM.)
Replace PU board.
Set properly.
Replace TIG board.
(Replace EEPROM.)
Replace engine control board (K7N).
Replace engine control board (K7N).
Replace engine control board (K7N).
Check for EEPROM and set if not
found.
Replace engine control board (K7N).
Replace engine control board (K7N).
Reload PU I/F.
Replace engine control board (K7N).
Display
Click on the first or last page to see other AR-C200P (serv.man3) service manuals if exist.
Random: