AR-C150 (serv.man103). Change carried out in the construction of the transfer waste toner tank unit. (WHITE) - Sharp Copying Equipment Technical Bulletin (repair manual). Page 2

CCE037 + CCE095

Sharp Electronics (UK) Ltd., Technical Services Group

[Note for servicing]
The toner reception BLT of an old-type waste toner tank unit is currently discontinued and is not supplied as a
service part. When replacing the toner reception BLT of an old-type waste toner tank unit (April 2002
production or before) in the market, use a new-type waste toner tank unit or replace with the toner reception
BLT (UCLEZ0161FCZZ) used in a new-type waste toner tank unit and replace with the toner reception holder
(LHLDZ1450FCZZ) and the toner reception Mylar (PSHEP4821FCZZ) at the same time.

(Replacement procedure of toner reception BLT of old-type toner tank unit)

1.  Remove three screws (No. 2 in the figure below) on the toner reception BLT, and remove the toner

reception BLT (No. 1 in the figure below) from the waste toner tank.
Note: The old-type toner reception BLT is fixed to the waste toner tank with duplex tape.
After removing the toner reception BLT, therefore, clean the surface and remove the tape dirt.

2.  Attach the toner reception Mylar (No. 12 in the figure below) to the toner reception holder

(No. 13 in the figure below).

Toner reception Mylar attachment reference: Use the rear frame side of the toner reception holder as the
attachment reference.

3. Attach the toner reception BLT to the waste toner tank.

4. Attach the toner reception holder (with the toner reception Mylar attached to it) on the toner reception BLT.
    Note: When assembling it to the waste toner tank unit, put the toner reception Mylar attachment surface upward.