Read Sharp AR-BD14 (serv.man5) Service Manual online
10. Open the printer junction board connector port on
the rear panel.
Remove the two screws which secure the connector cover plate of
the rear panel and remove the connector cover plate.
the rear panel and remove the connector cover plate.
Move the removed connector cover plate as shown and secure it with
the two screws.
the two screws.
11. Mount the rear panel.
Connect the connector of the printer junction board to the connector
port of the rear panel and replace the rear panel to its original posi-
tion.
port of the rear panel and replace the rear panel to its original posi-
tion.
At this time, check that the rear panel is securely mounted to the
copier.
copier.
Secure the upper part with the two screws and then tighten the four
lower screws to secure the rear panel.
lower screws to secure the rear panel.
Connect the RADF connector to the copier.
*
For Sweden only, attach the label.
12. Replace the ROMs on the operation panel control
board.
Remove the screw which secures the ROM cover and remove the
ROM cover.
ROM cover.
Then replace ROMs C and D on the operation panel control board
with the ROMs included with the AR-BD14.
with the ROMs included with the AR-BD14.
Replace the ROMs in accordance with the indications below.The
ROM for D varies with regions.
ROM for D varies with regions.
Replace the ROM cover to its original position and secure it with the
screw.
screw.
Close the front cover.
13. Stick the key sheet on the operation panel.
Stick the included key sheet on the operation panel as shown in the
figure.
figure.
14. Connect the Centronics cable.
Connect one connector of the Centronics cable (sold separately) to
the printer junction board connector.
the printer junction board connector.
Connect the other connector to the connector for laser printer on a
personal computer.
personal computer.
Caution:
In Europe and Australia, use a shielding type Centronics cable.
15. Check the operation.
For installation of the driver software to the personal computer. Then
execute printing from the computer and check that printing is per-
formed properly.
execute printing from the computer and check that printing is per-
formed properly.
(2) Installing Printer Drivers
A compatible printer driver must be loaded to enable a computer’s
operating system to communicate with the AR-5132 printer.
operating system to communicate with the AR-5132 printer.
The following procedures describe how to install each of the supplied
printer drivers. To install both of the Windows printer drivers, the
installation procedure must be performed twice.
printer drivers. To install both of the Windows printer drivers, the
installation procedure must be performed twice.
A. Windows 95
1. On the Windows 95 Start menu, highlight Settings, then highlight
and click on Printers.
Screws
Connector cover plate
Printer junction
board connector
board connector
Screws
Screws
Rear panel
Screw
Screw
Label
5 1
3 2
O P
P R O
V
5 1
3 2
O P
V
Screw
ROM cover
ROM for D
ROM for C
Indication on ROM for C
Indication on ROM for D
4
5
6
7
8
9
C
0
Key sheet
Printer junction board connector
Centronics cable
(sold separately)
(sold separately)
To connector for laser
printer on personal computer
– 7 –
Click on the first or last page to see other AR-BD14 (serv.man5) service manuals if exist.