Read Sharp AR-810 (serv.man20) Service Manual online
AR-651/810 RADF (DOCUMENT FEEDER) 16 - 82
(G-8) Intermediate transport sensor
(1) Open the platen sheet and remove 1 screw
fixing the band.
(2) Move the platen sheet toward the direction of
the white arrow to deflect the fulcrum and take
it off.
(3) Remove 2 screws and take off the scanning
end guide.
(4) Remove 4 screws and take off the small
original transport guide.
(G-7) APS operation sensor
(1) Remove the ADF rear cover.
(2) Disconnect 1 connector.
(3) Remove 1 screw and take off the APS
operation sensor with the bracket.
(4) While turning the sensor flag to deflect the
light shielding section from the sensor, release
the latches and take off the APS operation
sensor.
Sensor flag
Platen sheet
Small original
transport guide
transport guide
Scanning
end guide
end guide
(G-6) Tray width sensor
(1) Open the tray, remove 3 screws and take off
the back cover.
(2) Disconnect 1 connector, remove 1 screw and
take off the tray width sensor.
Note: Put together both marks at the rack and pinion
as shown by the right figure when installing the
tray width sensor.
APS operation sensor
Click on the first or last page to see other AR-810 (serv.man20) service manuals if exist.