Read Sharp AR-810 (serv.man20) Service Manual online
AR-651/810 RADF (DOCUMENT FEEDER) 16 - 8
(4) Start of feeding
The feed motor starts to rotate in reverse. After the feed motor has finished accelerating, the read motor
starts to rotate forward. With 1st original, both the feed and read motors start to slow down when the
leading edge of the original has come to a specified distance before the read sensor.
From 2nd original, the feed motor starts to slow down when the leading edge of the original has come to
a specified distance before the 1st roller. The feed motor stops rotating when the original length sensor
has detected the trailing edge of the original. At the same time, the tray lift motor starts to rotate to lift
the tray. When the tray has come to a specified level after the upper limit sensor had detected the top
side of the original, it stops rotating.
The empty sensor detects whether or not there is a next original with a specified delay after the original
length sensor has detected the trailing edge of the original. Without a next original, the tray lift motor
starts to lower the tray to turn the original set signal OFF. When the lower limit sensor has detected the
tray, it stops rotating. With a next original, the separation begins at the same time the scanning begins.
When the original has been transported a specified distance by the read motor after the read sensor had
detected the leading edge of the original, the read motor stops rotating and the original stop signal turns
ON.
(5) Start of 1st original scanning
The scanning begins after receiving the original transport signal from the copier. At the same time, the
original stop signal is reset. Then the read motor starts to rotate forward and to separate the next
original.
The SCN-STR turns ON when the leading edge of the original has reached the scanning section. When it
has been transported to the intermediate transport section and come to a specified distance before the
intermediate transport roller, the large original exit motor starts to rotate in reverse.
Feeding of 2nd original starts when the original has been transported a specified distance by the read
motor after the original length sensor had detected the trailing edge of the original.
Click on the first or last page to see other AR-810 (serv.man20) service manuals if exist.