AR-651 (serv.man25). AR651 810 Operation Manuals - Sharp Copying Equipment User Guide / Operation Manual. Page 2

In some areas, the "POWER" switch positions are marked "I" and "   " on the copier 
instead of "ON" and "OFF".
The symbol "   " denotes the copier is not completely de-energized but in a stand-by 
condition at this "POWER" switch position.
If your copier is so marked, please read "I" for "ON" and "     " for "OFF".

Warning
This is a class A product. In a domestic environment this product may cause radio 
interference in which case the user may be required to take adequate measures.

The CE mark logo label is affixed on an equipment in case that the directives described in the above 
sentence are applicable to the product. (This sentence is not applicable in any country where the 
above directives are not required.)

Required in IEC-950 (EN 60 950) - Europe
 •  The equipment should be installed near an accessible socket outlet for easy disconnection.

Required in Appendix ZB of BS 7002 (En 60 950) — United Kingdom

The mains lead of this equipment is already fitted with a mains plug which is either a non-rewireable
(moulded) or a rewireable type. Should the fuse need to be replaced, a BSI or ASTA approved fuse
to BS1362 marked            or 

         

and of the same rating as the one removed from the plug must

be used.
Always refit the fuse cover after replacing the fuse on the moulded plug. Never use the plug without
the fuse cover fitted.
In the unlikely event of the socket outlet in your home not being compatible with the plug supplied
either cut-off the moulded plug (if this type is fitted) or remove by undoing the screws if a rewireable
plug is fitted and fit an appropriate type observing the wiring code below.

DANGER: The fuse should be removed from the cut-off plug and the plug destroyed immediately
and disposed of in a safe manner. Under no circumstances should the cut-off plug be inserted
elsewhere into a 13A socket outlet as a serious electric shock may occur.

To fit an appropriate plug to the mains lead, follow the instructions below:
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:

As the colours of the wires in this mains lead may not correspond with coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured GREEN-AND YELLOW must be connected to the terminal in the plug
which is marked with the letter E, or by the safety earth symbol 

Å@

, or coloured green or green-

and-yellow.
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter
N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured red.

If you have any doubt, consult a qualified electrician.
WARNING: THIS APPARATUS MUST BE EARTHED.