Read Sharp AR-651 (serv.man25) User Guide / Operation Manual online
instead of "ON" and "OFF".
The symbol " " denotes the copier is not completely de-energized but in a stand-by
condition at this "POWER" switch position.
If your copier is so marked, please read "I" for "ON" and " " for "OFF".
For a complete electrical disconnection, pull out the main plug.
The socket-outlet shall be installed near the equipment and shall be easily
This is a class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
sentence are applicable to the product. (This sentence is not applicable in any country where the
above directives are not required.)
• The equipment should be installed near an accessible socket outlet for easy disconnection.
(moulded) or a rewireable type. Should the fuse need to be replaced, a BSI or ASTA approved fuse
to BS1362 marked or
Always refit the fuse cover after replacing the fuse on the moulded plug. Never use the plug without
the fuse cover fitted.
In the unlikely event of the socket outlet in your home not being compatible with the plug supplied
either cut-off the moulded plug (if this type is fitted) or remove by undoing the screws if a rewireable
plug is fitted and fit an appropriate type observing the wiring code below.
and disposed of in a safe manner. Under no circumstances should the cut-off plug be inserted
elsewhere into a 13A socket outlet as a serious electric shock may occur.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
identifying the terminals in your plug, proceed as follows:
The wire which is coloured GREEN-AND YELLOW must be connected to the terminal in the plug
which is marked with the letter E, or by the safety earth symbol
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter
N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured red.
WARNING: THIS APPARATUS MUST BE EARTHED.
off. The copier must also automatically change to a 'Low Power Mode' (Automatic Energy Save) after a period
of time since the last usage.
For Copier+Printer models,
copier must also automatically change to a 'Low Power Mode' (Automatic Energy Save) after a period of time since
the last usage.
Specifically, this copier complies with the following requirements ––––
Note2- To restart the copier auto shut off, turn on the power switch. To restart the copier after sleep mode,
please contact your authorised Sharp dealer.